Vacuum positioning mat holds patients in the desired position, prior to a surgical procedure, ultrasound, MRI, CT or X-rays. Easy to use,you just need to place the animal in the desired position and pump the air out in less then 10 seconds.Easy to clean, as you can run it under a tap or simply wipe it down.
Exterior made of polyurethane material, durable and easy to clean.
Radiation permeable, suitable for ultrasound, DR, CT and MRI, surgery, etc.
Perfectly adapts to the pet's position on demand, especially for non-routine surgeries such as ophthalmology.
High-quality safety valve that pumps in 10 seconds and stays on for over 72 hours.
Application Scenarios
1.Surgery
Positioning mat can be used in surgery to fixate the surgical site of the animal, to support the
surgical area, to provide a comfortable posture, to reduce surgical trauma, and to immobilize
the fracture of the animal.
2.For inspection
Vacuum Positioning Mat can be used for transillumination and are suitable for ultrasound, DR,
CT and MRI scenarios, making it easy to examine and analyze the animal's body condition.
3.For rehabilitation
Vacuum Positioning Mats are often used in rehabilitation to support and stabilize the body of
patients with paralysis, limb dysfunction, etc., and to help rehabilitate animals.
General
| Material |
Polyurethane material |
| Dimension |
40*60 CM |
| Product package |
1*mat,1*pump |
Use Instruction
1.Check the positioning mat before use to ensure they are in good condition.
2.Place the positioning mat horizontally on a flat surface and gently press
it with your hand to make the particles evenly distributed.
3.Check whether the pump is well connected to the connecting tube;whether the connecting tube is well connected to the air nozzle; and whether the air nozzle end of the connecting tube is connected to the air valve on the positioning mat.
4.Use an air pump to pump out a small amount of air, so that the positioning mat is in a slightly tighter state, in order not to affect the positioning and shaping operations, whichever.
5.The animal is laid flat on the positioning mat, the positioning mats are wrapped around the treatment area and then shaped.
6.After the initial molding is completed, the air pump is used to pump out part of the air in the positioning mat to form a model
that basically fits the animal's body.
7.According to the actual situation of the molded model to do further fine-tuning, after the adjustment is completed, use the pump again, so that the pad to achieve a vacuum state, the formation of the final model. Usually it is recommended to pump and shape in three to five times during the molding operation, which can make the product more comfortable. Reduce the difficulty of operation and better fixing effect.
8.After finishing shaping, remove the pump and cover the valve cover.
9.After use, open the valve cover to lift the vacuum inside the pad and clean the surface.
Audited Supplier 
){kind=link}